服务中心   Service Center
沧州鹏宇铸造机械厂
地址:河北省献县城北开发区
崔  旭:18703376987
王淑英:13780574987
http://www.pyshexinji.com
首页 > 新闻咨讯 >   射芯机的注意事项

射芯机的注意事项

发布时间:2020-01-11
6.1对本设备操作没有进行过培训的人员不得操作本设备。
6.1 Personnel who have not been trained in the operation of the equipment shall not operate the equipment.
6.2在进行自动运转前必须经手动空转。
6.2 Manual idling is required before automatic operation.
6.3开动前要检查运动部件中有无导物、有无非设备操作人员靠近。不要将工具等杂物放在设备上。
6.3 Before starting, check whether there are conductors in the moving parts and whether there are non-equipment operators approaching. Do not put tools and other debris on the equipment.
6.4设备在运转中,不允许触摸运动部分及电器元件。
6.4 When the equipment is in operation, it is not allowed to touch the moving parts and electrical components.
6.5因外部供电中断运转中的设备突然停止工作时,要切断设备电源开关以免再来电造成危险。
6.5 When the equipment in operation suddenly stops working due to the interruption of external power supply, the power switch of the equipment should be cut off so as to avoid the danger of re-electricity.
6.6在设备维修、检查、调整、清理等工作中。应切断总电源和压缩空气总阀门。
6.6 In equipment maintenance, inspection, adjustment, cleaning and other work. General power supply and compressed air valve should be cut off.
6.7在维修、检查、调整电磁阀后有可能未恢复到原来状态,通电、通气后要注意观察,以免发生意外动作造成危险。
6.7 The solenoid valve may not be restored to its original state after maintenance, inspection and adjustment. After electrification and ventilation, attention should be paid to observation so as to avoid the danger caused by accidental action.
6.8设备各部分在工作中如出现异常声音、嗅味等不正常现象时应立即停止运行。检查调整后必须先进行手动空转试车。
6.8 All parts of the equipment should be stopped immediately if abnormal phenomena such as abnormal sounds and smells occur in the work. After inspection and adjustment, manual idle test run must be carried out first.
6.9设备工作后停机必须停在原始位置,然后切断电源、气源。
6.9 After the equipment works, it must stop at the original position, then cut off the power supply and gas source.

当前地址:http://www.pyshexinji.com/news/761/  作者:鹏宇射芯机
热门推荐