服务中心   Service Center
沧州鹏宇铸造机械厂
地址:河北省献县城北开发区
崔  旭:18703376987
王淑英:13780574987
http://www.pyshexinji.com
首页 > 新闻咨讯 >   射芯机操作和保养

射芯机操作和保养

发布时间:2020-01-11
射芯机操作和保养Operation and maintenance of the core ejection machine下面这些你是不是都做到了?Are you doing all this next?1 开动射芯机前,应先检查射芯机的润滑装置是否完善,并按规定加油,检查各紧部件是否紧固,各操作手柄是否处于零位(空位),气阀动作是否灵活,管路有无漏气,然后打开总气阀放掉管路中的积气和积水。1 start shooting machine before, should first check the lubrication device of the core shooting machine is perfect, and according to the provisions of the gas, check the tension member is fastened, the operating handle is zero (vacancy), valve action is flexible, pipeline without leakage, and then open the total valve gas and water drain pipeline the.3 射芯机使用时要认真观察运转情况,在操作中应经常用空气吹净润滑部位和运转部位的砂粒,严禁各润滑部位粘砂。3, when the core machine is used, we must carefully observe the operation. During operation, we should always use air to blow the sand parts of the lubrication parts and the running parts, and strictly prohibit the sand sticking of the lubricating parts.4 每完成一次造型工作后要将工作台清理干净,才能进行第二次造型工作的开始。4 after each completion of the work to clean up the workbench, can the start of the second modeling work.5 射芯机使用完毕后,要将手柄回到零(空)位,关闭各阀门,清扫设备,打扫现场,要保持设备各滑动(转动)部位的清洁和润滑,认真收检工具,模具。5 after the core machine is used, it is necessary to return the handle to the zero (empty) position, close the valves, clean the equipment, clean the scene, keep the parts of the sliding and rotating parts clean and lubricated, and carefully check the tools and moulds.
当前地址:http://www.pyshexinji.com/news/769/  作者:鹏宇射芯机
热门推荐