服务中心   Service Center
沧州鹏宇铸造机械厂
地址:河北省献县城北开发区
崔  旭:18703376987
王淑英:13780574987
http://www.pyshexinji.com
首页 > 新闻咨讯 >   立式射芯机的保养注意事项

立式射芯机的保养注意事项

发布时间:2020-01-11
立式射芯机的保养注意事项:Precautions for maintenance of vertical core ejection machine:1.射芯机开合模的动模板轴套部位有注油咀,每班注一次润滑脂,少量注,不要注满。1. there is an oil filling nozzle on the moving template shaft sleeve of the opening and closing die for the core shooting machine.2.射砂筒导杆每两班注一次润滑脂,不要注满。2. the guide bar of the shot sand cylinder is lubricated twice every time.3.射芯机带有工作台的导杠也要每班注一次润滑脂,不要注满。3. the core of the core machine with the guide bar of the worktable must also be lubricated once a time.4.每班工作前要检查运动部位是否有灰尘、油污和杂质等,每班工作结束后要把砂清理干净,外部和内部的包括射砂筒于装砂筒。4. before the work of each class to check whether there is dust, oil pollution and impurities, and so on. After the end of each class, the sand should be cleaned, and the outside and inside of the sand barrel in the sand barrel.5.要经常排除滤清器的水,和储气罐的水。5. always exclude water from filters and water from tanks.6.要经常检查油杯的油是否够用,底于下线时就要加入润滑机油,以保证气缸充分的润滑。6., check the oil of the oil cup regularly enough. When the bottom is on the line, lubricating oil must be added to ensure that the cylinder is fully lubricated.7.带有液压站的射芯机,要经常检查是否漏油、渗油、压力不稳、液压油量的多少、油温高低,带有散热器检查散热口是否堵塞,压力调整好后调压阀要锁死,压力表也要关闭以防损坏,电机是否有噪音和发热等。7. the core ejection machine with the hydraulic station should check the oil leakage, oil seepage, pressure instability, the amount of hydraulic oil and the oil temperature, with the radiator check whether the heat sink is blocked, the pressure adjustment valve should be locked after the pressure adjustment is good, the pressure gauge must be closed to prevent damage, the motor is not noisy and heat.
当前地址:http://www.pyshexinji.com/news/778/  作者:鹏宇射芯机
热门推荐