服务中心   Service Center
沧州鹏宇铸造机械厂
地址:河北省献县城北开发区
崔  旭:18703376987
王淑英:13780574987
http://www.pyshexinji.com
首页 > 新闻咨讯 >   双工位射芯机在工作中要注意的事项

双工位射芯机在工作中要注意的事项

发布时间:2020-01-11
双工位射芯机在工作中要注意的事项:Matters needing attention in the work of double station core shooting machine:1、射芯机在工作中不能随便调整电器,要在一个循环结束以后再调整,否则可能会造成人员受伤。1, the core shooting machine can not adjust the electrical appliances at any time, it should be adjusted after the end of a cycle, otherwise it may cause injury.2、在射芯机没有断电断气之前,将手放入空隙处或导轨上都是危险动作,可能会发生伤亡事故。2. Before the core shooting machine is cut off without power, it will be dangerous action to put the hand in the gap or the guide way.3、射芯机在一个工作循环结束以后要用喷咀清理上面余留下来的啥子,在喷涂一层分型剂。3. After the completion of a working cycle, the core shooter should use the nozzle to clean up what is left over, and spray a layer of parting agent.4、手动操作时,每次只能操作一个电器开关。4. Manual operation can only operate one electrical switch at a time.5、通常情况下,射芯机是不允许空射的,如果必须空射,要关小压缩空气阀门。5, under normal circumstances, the core shooting machine is not allowed to shoot, if you must shoot the air, to turn off the small compressed air valve.
当前地址:http://www.pyshexinji.com/news/784/  作者:鹏宇射芯机
热门推荐